Thursday, May 28, 2015

Circuit Schematic Switching Voltage Regulator using ADP3610 IC

Eltronicschool. - There are many electronic circuit that special designed for Switching Voltage Regulator. One Circuit Schematic Switching Voltage Regulator using ADP3610 IC like in figure 1 below.

In this time we will show you Circuit Schematic Switching Voltage Regulator using ADP3610 IC and also the description.

Circuit Schematic

Switching Voltage Regulator circuit daigram
Circuit Schematic Switching Voltage Regulator using ADP3610 IC / www.circuitlab.org

Component List
  • The main component is ADP3610 IC
  • All component see in figure 1 above

Description

Circuit schematic like in figure 1 abve is Circuit Schematic Switching Voltage Regulator using ADP3610 IC. The Analog Devices ACP3610 is a voltage doubler that works with a switched-capacitor converter, using the push-pull principle. The switching frequency at the output is approximately 550 kHz. The term ‘push-pull’ refers to the two charge pumps, which work in parallel but in opposite directions in order to deliver the output voltage and current. 

Whenever one capacitor is supplying current to the output, the other one is being charged. This technique minimizes voltages losses and output ripple. The converter works with input voltages between 3 and 3.6 V. It provides an output voltage of around 6V at a maximum current of 320mA, if 2.2µF switched capacitors with low ESR (equivalent series resistance) are used. 

Read more the description here


Thank you for your coming here in www.eltronicschool.com site, we hope the article above will help you to know more about your an electronic circuit design and software in this time, etc. Please comment here when you want to share and other. Thank you.

0 comments:

Post a Comment

Thank's for your reading in this article, please don't forget to comment.